Please activate JavaScript!
Please install Adobe Flash Player, click here for download

FBR March 2016

SOLUTIONS F ailure to remove water vapour from factory air can quickly become a costly maintenance headache. According to Brian Abbott, Product Manager at SMC Pneumatics South Africa, water vapour and the resulting water condensate are the foremost causes of downtime and increased maintenance. “The blame is often laid on the more visible culprit - oil or contaminants - both of which are easily removed with proper filtration.” “Moisture in facility airlines can cause corrosion and rust which can break loose in the air passageways, causing blockages in narrow restrictions and filter elements. This can lead to pressure drops and loss in machine performance, not to mention energy loss and the costs of the compressed air,” says Abbott. Aftercoolers, drip legs and water separators are used to remove water condensate from factory compressed air. However, this air is still at 100% relative humidity and is still at risk of condensing into water should the surrounding temperatures drop to its dew point. In order to increase protection of expensive automation equipment, factory compressed air must remove as much water vapour as possible to avoid any condensation further downstream. This is done by lowering its dew point. Abbott says drying compressed air at the highest pressure consistent with the facility’s demands will result in the most economical dryer operation. For most industrial applications, the rule is to first set the pressure dew point to meet general requirements, then adjust it between -6°C to -10°C lower than the facility’s lowest ambient temperature. Hence, factory air dryness or dew point is relative to the application’s specific requirements. Refrigerated dryers are the most commonly-used method to lower dew point. A refrigerated dryer will further cool the compressed air by removing heat at its inlet side, lowering its temperature dew point down to 3°C and then expelling the condensate through an automatic condensate drain. The dryer will then reheat the dried compressed air back to ambient temperature by recycling the previously removed heat using a heat exchange process. This reheating of the compressed air to ambient temperature will eliminate “sweaty” cold pipes when working in humid factory conditions. ... Continued on next page Vapour: a costly curse ... Abbott ... get that dew point right.

Pages Overview